RD-0214

From Infogalactic: the planetary knowledge core
Jump to: navigation, search
RD-0214 (РД-0214)
Country of origin USSR
First flight RD-0207:1963-11-06[1]
RD-0214:1967-03-10[2]
Designer OKB-154, Yankel I. Guerchkovitch[2][3][4]
Manufacturer Voronezh Mechanical Plant
Application Vernier Engine
Predecessor RD-0207
Status In Production
Liquid-fuel engine
Propellant N2O4[2] / UDMH[2]
Mixture ratio 2.54[4]
Cycle Gas Generator[2]
Configuration
Chamber 4
Performance
Thrust (vac.) 30.9 kilonewtons (6,900 lbf)[2]
Chamber pressure 5.3 megapascals (770 psi)[2]
Isp (vac.) RD-0207:297seconds[5]
RD-0214:293 seconds[2]
Burn time RD-0207:133seconds[5]
RD-0214:270s[2]
Dimensions
Length 524 millimetres (20.6 in)[4]
Diameter 3,780 millimetres (149 in)[4]
Dry weight 90 kilograms (200 lb)[2]
Used in
Proton third stage

The RD-0212 (GRAU Index: 8D811) is a rocket vernier engine burning N2O4 and UDMH in a gas generator cycle. It has four nozzles that can each gimbal 45 in plane to provide TVC to the RD-0212 propulsion module of Proton third stage. It is a revised version of the RD-0207.[4]

Development

When Chelomey's OKB-52 started their UR-200 ICBM project, they requested S. A. Kosberg's OKB-154 to develop the propulsion. For the second stage, they used a single RD-0206, a variation of the first stage RD-0203, but required a vernier engine. To this end, the RD-0207 vernier engine was designed. It also included a heat exchanger to heat the pressurant gases for the second stage tank.[4][6][7] While the UR-200 project was in direct competition to the R-36 and was cancelled in favor of the latter, it did had a few test launches and thus was a proven design.[4][6][7]

Then Chelomey moved his proposals to the super heavy ICBM UR-500 (8K82) and later to the Proton-K (8K82K). A heavy launch vehicle that could perform important missions for the Soviet moonshot. For this new missions, it would not need to comply with ICBM specification standards, but would need at least a third stage. For the third stage, the UR-200 second stage was adapted - with the same 4.1m tanking as the first and second stages- and the RD-0205 module with an RD-0206 and an RD-0207 vernier engine was given an overhaul. The new module, - known as RD-0212 - consisted of an RD-0213 and an RD-0214 vernier engine. Many reliability enhancements were done and much extra tests firings were performed. Yet, even as of 2015 design issues where found to have caused failures.[4][8][9][10]

History

The first launch test of the UR-200 was on November 5, 1963 and was unsuccessful. The second vehicle, launched on April 11, 1964, also failed. The final RD-0207 flight was on October 20, 1964.

The first RD-0214 flight was on October 3, 1967.

On September 15, 1968 the RD-0214 module launched the Zond 5 around the Moon on a free return trajectory, that sent the first alive organisms around the moon and back to Earth.[11]

On 19 May 1971 a Proton launched the Mars 2 probe to Mars. The orbiter was identical to the Venera 9 bus, and the lander was the first man made object to reach the surface of Mars.[11]

On 8 June 1975 a Proton launched the Venera 9 to Venus. It consisted of an orbiter based on the Mars 2 design, and a lander which was sent the first pictured from the surface of Venus.[11]

Versions

There are two basic versions of this engine:

  • RD-0207 (GRAU Index: 8D67): A small gas generator rocket vernier engine using the same propellants as the RD-0206 and bundled with it in the RD-0205 propulsion module. It has four combustion chambers that can gimbal 45 degrees in a single plane and allow the UR-200 second stage to have vector control.[5]
  • RD-0214 (GRAU Index: 8D811): An evolution of the RD-0207 engine, used as vernier engine of the RD-0212 propulsion module along the RD-0213. It has four combustion chambers that can gimbal 45 degrees in a single plane and allow the Proton third stage to have vector control.[12]

Modules

These engines are actually bundled into modules. The relevant modules and auxiliary engines are:

  • RD-0205 (GRAU Index: 8D46): A module comprising an RD-0206 and an RD-0207 vernier engine. Propulsion of the UR-200 second stage.[13]
  • RD-0212 (GRAU Index: 8D49): Also known as the RD-473, it is a propulsion module comprising one RD-0213 and an RD-0214 vernier engine. Propulsion module of the third stage of the Proton rockets.[14]

See also

References

  1. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  2. ↑ 2.0 2.1 2.2 2.3 2.4 2.5 2.6 2.7 2.8 2.9 Lua error in package.lua at line 80: module 'strict' not found.
  3. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  4. ↑ 4.0 4.1 4.2 4.3 4.4 4.5 4.6 4.7 Lua error in package.lua at line 80: module 'strict' not found.
  5. ↑ 5.0 5.1 5.2 Lua error in package.lua at line 80: module 'strict' not found.
  6. ↑ 6.0 6.1 Lua error in package.lua at line 80: module 'strict' not found.
  7. ↑ 7.0 7.1 Lua error in package.lua at line 80: module 'strict' not found.
  8. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  9. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  10. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  11. ↑ 11.0 11.1 11.2 Lua error in package.lua at line 80: module 'strict' not found.
  12. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  13. ↑ Lua error in package.lua at line 80: module 'strict' not found.
  14. ↑ Lua error in package.lua at line 80: module 'strict' not found.

External links

Retrieved from "https://infogalactic.com/w/index.php?title=RD-0214&oldid=721900529"