South African Class 6H 4-6-0

This article is about one of several different Cape Government Railways locomotive types to be designated "6th Class". For other CGR 6th Class locomotives, see Cape Government Railways 6th Class locomotives.

CGR 6th Class 4-6-0 1901 Neilson Reid
South African Class 6H 4-6-0

300px CGR 6th Class no. 607, then no. 547, SAR Class 6H no. 629, at Midlandia Loco, Noupoort

Type and origin Power type Steam Designer Cape Government Railways (H.M. Beatty) Builder Neilson, Reid and Company Serial number 5871-5891 Model CGR 6th Class Build date 1901 Total produced 21

Specifications Configuration 4-6-0 (Tenwheeler) Driver axle 2nd coupled axle Gauge 3 ft 6 in (1,067 mm) Cape gauge Leading dia Coupled dia 54 in (1,372 mm) Tender wheels as built 34 in (864 mm) retyred Wheelbase  • Engine 20 ft 8 in (6,299 mm)  • Leading 5 ft 6 in (1,676 mm)  • Coupled 11 ft 4 in (3,454 mm)  • Tender 14 ft 7 in (4,445 mm)  • Tender bogie 4 ft 7 in (1,397 mm) Wheel spacing (Assymetrical) 1-2: 4 ft 9 in (1,448 mm) 2-3: 6 ft 7 in (2,007 mm) Length:  • Over couplers Height 12 ft 10 in (3,912 mm) Frame type Plate Axle load  • Leading  • Tender bogie Bogie 1: Bogie 2:  • Tender axle Adhesive weight Loco weight Tender weight Loco & tender weight Tender type XD (2-axle bogies) XC, XC1, XD, XE, XE1, XF, XF1, XF2, XJ, XM, XM1, XM2, XM3, XM4, XP1, XS permitted Fuel type Coal Fuel capacity 5 LT 10 cwt (5.6 t) Water cap Boiler:  • Pitch 6 ft 10 in (2,083 mm)  • Diameter 4 ft 6 in (1,372 mm)  • Tube plates  • Small tubes 185:  • Firebox type Round-top Boiler pressure 180 psi (1,241 kPa) 170 psi (1,172 kPa) adjusted Safety valve Ramsbottom Firegrate area 18 sq ft (1.7 m2) Heating surface 1,130 sq ft (105 m2)  • Tubes 1,015 sq ft (94.3 m2)  • Firebox 115 sq ft (10.7 m2) Cylinders Two Cylinder size 17 in (432 mm) bore 26 in (660 mm) stroke Valve gear Stephenson Couplers Bell link-and-pin AAR knuckle (1950s)

Performance figures Tractive effort 18,780 lbf (83.5 kN) @ 75% 17,740 lbf (78.9 kN) @ 75% adjusted

Career Operators Cape Government Railways South African Railways Class CGR 6th Class, SAR Class 6H Number in class 21 Numbers CGR 278-286, 601-612 (541-552) SAR 614-634 Delivered 1901 First run 1901

The South African Railways Class 6H 4-6-0 of 1901 was a steam locomotive from the pre-Union era in the Cape of Good Hope.

In 1901, twenty-one 6th Class 4-6-0 steam locomotives were placed in service by the Cape Government Railways, built to the older 6th Class designs, with plate frames. In 1912, when they were assimilated into the South African Railways, they were renumbered and reclassified to Class 6H.

Manufacturer

The original Cape 6th Class locomotive was designed at the Salt River works of the Cape Government Railways (CGR), at the same time as the 7th Class.

File:H.M. Beatty.jpg

H.M. Beatty

Three new versions of the 6th Class locomotive entered service on the CGR in 1901, two American-built and one British-built. The British versions were built by Neilson, Reid and Company, who delivered twenty-one engines. With these locomotives, CGR Chief Locomotive Superintendent H.M. Beatty kept to the older plate frame design, but fitted the larger type of cab. These locomotives also reverted to the 17 inches (432 millimetres) diameter cylinders, which had been used on all previous 6th Class locomotives, with the exception of the Class 6G. Having been built with plate frames, another similarity to the early 6th Class locomotives was their lower running boards, with fairings or splashers over the coupled wheels.

Upon delivery, nine of them were numbered in the range from 278 to 286 and allocated to the Western System of the CGR. The other twelve were numbered in the range from 601 to 612 for the Midland System, but later renumbered in the range from 541 to 552.

Drummond tubes

One of these locomotives, the Western System's no. 286, was an experimental locomotive, equipped with Drummond water tubes in the firebox and a very large panelled cab. Drummond tubes involved the installation of cross-water tubes in the firebox, as featured on the London and South Western Railway's T9 Class and L11 Class, in an attempt to increase the heat surface area of the water, albeit at the cost of increased boiler complexity. On CGR no. 286, as built, visual exterior evidence of the presence of Drummond tubes was rectangular covers, attached to the sides of the firebox just ahead of the cab.

In service, it was found that the tubes did not affect the steaming capacity of the boiler to any significant extent. Instead, the tubes were inclined to leak and were difficult to maintain. It was therefore not long before the tubes were removed, and at the same time the cab was changed to the standard type, as used on the other twenty locomotives.

Class 6 sub-classes

When the Union of South Africa was established on 31 May 1910, the three Colonial government railways (CGR, Natal Government Railways and Central South African Railways) were united under a single administration to control and administer the railways, ports and harbours of the Union. Although the South African Railways and Harbours came into existence in 1910, the actual classification and renumbering of all the rolling stock of the three constituent railways required careful planning and was only implemented with effect from 1 January 1912.

When these locomotives were assimilated into the South African Railways (SAR) in 1912, they were renumbered in the range from 614 to 634 and designated Class 6H.

The rest of the CGR's 6th Class locomotives, together with the Central South African Railways (CSAR) Classes 6-L1 to 6-L3 locomotives which had been inherited from the Oranje-Vrijstaat Gouwerment-Spoorwegen (OVGS) via the Imperial Military Railways (IMR), were grouped into thirteen more sub-classes by the SAR. The 4-6-0 locomotives became SAR Classes 6, 6A to 6G and 6J to 6L, the 2-6-2 locomotives became Class 6Y and the 2-6-4 locomotives became Class 6Z.

Service

The Class 6 series of locomotives were introduced primarily as passenger locomotives, but when the class became displaced by larger and more powerful locomotive classes, it literally became a Jack-of-all-trades. It went on to see service in all parts of the country, except in Natal, and was used on all types of traffic.

Renumberings

The table lists the Class 6H works numbers and renumberings.

Class 6H 4-6-0
Works Numbers & Renumbering

Works no.	CGR no.	CGR Renumber	SAR no.
5883	278		614
5884	279		615
5885	280		616
5886	281		617
5887	282		618
5888	283		619
5889	284		620
5891	285		621
5890	286		622
5871	601	541	623
5872	602	542	624
5873	603	543	625
5874	604	544	626
5875	605	545	627
5876	606	546	628
5877	607	547	629
5878	608	548	630
5879	609	549	631
5880	610	550	632
5881	611	551	633
5882	612	552	634

Commemoration

A 25c postage stamp which depicted a Class 6H locomotive, was one of a set of four commemorative postage stamps which were issued by the South African Post Office on 27 April 1983, to commemorate the steam locomotives of South Africa, which were rapidly being withdrawn from service at the time. The artwork and stamp design was by the noted stamp designer and artist Hein Botha.

The particular locomotive depicted was ex CGR (Midland System) 6th Class no. 605, renumbered to CGR no. 545 and later SAR Class 6H no. 627, which was withdrawn from service in 1971 and plinthed at the Mafikeng Museum in 1972. The outline of a traditional SAR locomotive number plate was used on the date of release, as a commemorative cancellation for De Aar.

Illustration

The main picture and the following show the differences in appearance of the Class 6H during its service life, with different cabs, headlights and cowcatcher designs.

• CGR 6th Class no. 286 Drummond.jpg

  CGR Western System no. 286, as built, with Drummond tubes and large cab

• SAR Class 6H 631 (4-6-0) ex CGR 609-549.jpg

  Ex CGR Midland System 6th Class no. 609, renumbered to CGR no. 549 and later SAR Class 6H no. 631, with a large headlight

• SAR Class 6H 631 (4-6-0) CGR 609 CGR 549.jpg

  SAR Class 6H no. 631, ex CGR Midland System 6th Class no. 609, later renumbered to CGR no. 549, with a smaller round headlight and without a cowcatcher